BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL ,n N~ITE j"''JCTH~ ~ED OR i ~z 1,4 IN,--_-4 --- r 3 4 iN, SOFT WIRE SOLDER :IM1NG MARK.J FIGURE 7A-17. MAGNETO TIMING MARKS FIGURE 7A-1'. TIMING POINTER c. Ratite coupling from neutral. in a left hand direction 10·, Appcarina tht0Ulh timing hole. when the white or red tooth aliens with the white line of the distributor block, me ma,neto is set at "E" gap. (Refer to Fifure 7 A-11.) A.lipment ma,.,not vary over 4·. d. Using the ali,nment of the chamiered tooth on the distributor JCat a..,d the white line on the distributor block as a reference. adjUSt the bre&ker paints to open at this point.

Tum the magneto dnvc until the cam follower is on high point of the cam lobe. Measure contact elcan.nce, it must be .018 inch = .006 with the point opening set ilt "E" gap ± 4- 0. If breaker poina do not come within tolerances. they should be repiaced. 7.-\-72, AdjusciDg Reurd Breaker PoiDa -200 Seria M.,nctos. a. Install timing plate ilftd pointer on mllnttos without amln, muks cast in the breaker compartment (refer to FiJurc 7.-\-19) or JUSt the pointer on mqnetos with cimini marks cast in the breaker compartment. (Refer to FiJure 7 A-20.) NOTE A timing kit. inc:ludin, timing plate. etc. may be purchased through the engine or m&JTleto manufacturer.

A pointer may be fanned as shown in FilUre 7A-18. .-\ pointer can usa be made by wra!'ping a piece of soft wire tighdy around the head of cam securing screw and bending it to extend over NOTE timing marks. POWER PLANT ISSUED: 8/18/72 2 D21