PIPER COMANCHE SERVICE MANUAL a.. Position the bottom cowlm, and secure with screws to the firewall bulkhead. b. Sec:ure the ,ear door frame channcls to thc firewall and enginc mount straps uslnf auaching screws. 7C·7. lnscaUaDon Of Enpac Cowlin,. c. Conne!:t cowl nap conual cables to flap a.cn&atiq urns. 4. Conncct Jar door &CaIaWlt rods to doors. e. Connect cinin cubes to outlet in bottom cowl. f. Poation tOp cowl on enriDc assembly. g. AttaCh t,q! cowl SIlppon chaMcis to the fuewaU with screws, washers and llUes. h. Secure the cowl nose section halves with screws. l, Sec:uretop cowl to firewall bulkhead widl screws. j. Adjust note gear door. (Refer to Section Vl.) k.
Secure side panels with fasteners. 7C·8. Propeller. CAtlTION Before pcrfonninl any service functions on the propeller. uccnaift that the master switch is OFF. the masnno switches arc OFF (,rounded) and the mixture eeaerel is in the lDLE CUT-oFF position. 7C·9. RemovaJ Of Propclkr.(Rcfer to Figure 7C·1.) a.. Ascertain that muter switch and rnqneto switches are in the OFF position. b. In some manner identify the position of each pan: in relation to the other to facilitate installation. c. Remove the spinner (1) by removing the screws that sccure it to the spinner bulkhead, d. Remove the en,me eowli,.. (Refer to parapph 7C·!.) e. Place a drip pan under. the propeller to catch oil spillap. f.
Cut the safety wire around the propeUer mounti,. SfUds (7) and remove the SNds from the engine flanse. The nuts arc froun and pinned to the studs, so the sNds will tum with the nuts. g. Pull the propeller from the eftJine shaft. h. Remove the propeller aoring (9) from the propeUer hub Ooring groove. i, The spinner bulkhead (10) may be removed from' the staner ri,. gear by removing :11.lt5 and wuhen. POWER PLANT ISSUED: 8/18/72 2 611