PIPER COMANCHE SERVice MANUAL 1002. ., I. '~'III1&. Z. ~.O~,~~& ~.O, J. ~OW ~'TCM "OJlI'T"'IIT ... ~OCK "liT t. I.'''''' "~111' ~lIT T. ,'UO I. "O,,~ .. , .. t. "0" .,", n,,~ '0. '~'II"'" -a"'." '.0 r r , , .... ,., ., ",. u ... FIGURE 7C·1. PROPELLER INSTALLATION 7C·10. Clcaninl.lnlpeCtion And Repair Of PropdJcr. (Refer to FiJUte 7C·2.) a. Check for oil and rrcue leaks. b. Clean the spinner. propeller hub and blades with a non-eorrosivc solvent. c. Inspect the hub partS for cracks. d. Steel hub puts should not be permiacd to euse. Usc duminum paint to touch up. if necessary. or replace durin, overhaul. e. Check aJl visible partSfor wear and safety. f.
Check blades to determine whether they tum freel)' on the hub pivot rube. This can be done by !'ocking the blades back and forth throulh the slitht freedom allowed by the pitch change mechanism. If they appear tight and are properly lubricated. the propeller should be disassembled by an authorized ServiceCenter. g. Inspect blades for damage or cncks. Sicks in leading edges of blades should be filed out and ail edges rounded. as cracks somet1D'les start from Ncb places. Usc fine emery cloth for finishing. h. It IS recommended tnat for severe dam internal repairs and replacement of partS. the propeller should be refcned to the ~anufacturer or a Certified Repair Station. i.
Grease blade hub through Ink finint. Remove one of the cwo fittings for each prceeller blade. ,uternate the next time. Apply grease through the zerit fittll\! until fresh p-ease appesn at the fimn, hole of the removed fitting. Cue should be taken to avoid blOWing OUt hub gaskets. 2 812 POWER PLANT ISSUED: 8/18/72