PIPER COMANCHE SERVICE MANUAL Ell8ggerated View of nicks rn leading edge E"aggerated vIew of nick In face of blade /It.: Recommended method for re- movong niCkSbv rtffle hie Ind crocus cloth. Blend deepest portIOn of "'Ck Into leadi"g edge 1119'" me"t With smooth curves SECTION A.A- Nick ,n face of blade rerT'oved by "Ie ann crocus cloth 3S recommended FIGURE 7C·%' "TYPICAL NICKS AND REMOVAL METHODS 1C·ll. InsaUadon Of PropeUcr. (Refer to Fipre 1C·l.) a, Clan propeller &ad enpne flanps. b. Install spiMU bulkhnd (10) on scatter rine par. and torque bolts to specifications given in Ta.ble VUC·I. c.
Observe the surtCT rin, sur to make sure it is mounted properly on the engine crankshaft fla.r.~e. The crankshaft f1anIe is scamped with &.D "0" mark a.nd the starter tin, gear is Ijkewise identified by an "0" mark. Upon insW1&tion of the staner rins gear. the markinp shall be mated to insure proper instaU&tion. cl. Lllbricate and install o-nn, (9) in the propeller hub 00rinI JfOOvc. e. ."'ollnt propeller on engiDe. Screw each stUd (7) into io maan, fWlJe busbinl a. few thrcads it a. time IIntil all are ript. Torque bolts to spec:ifications Jiven in Table VUC·1. Succy the mounting bolts with MS2099SC41 wirc. routiftl the wire wouBb the lock pins (8). f. Check blade auk per puqrapb 1C·U. g.
Install mpae cowlins. (Reier to parqraph 7C·7.) h. Install spinner (1) and secure with screws. iC·12. AdjlllUllCDt Of Low Pitch Blade Anpe Seop. a. The propeller comes from the fa.ctory with the low pitch Stop a.djusted for proper blade angle. If. howeYer. this adjustment bu been dimarbcd• .the followin, procedUI'C is given for Obtaining blade angle; 1. The blade angle (refer to Table Vue·1) is detennined by plaCing a propeller protractor on the face side of the propeller. at the 30 inch station. as measured from the hub center line. T!1c blade must be horizontal. POWER PLANT ISSUED: 8/18172 2813