PIPER COMANCHE SERVICE MANUAL 7C-35. Fuel Injector. a. In general. little attention is required between injector overhauls. However. it is recommended that the following items be checked during periodic inspection of the engine. 7C-36. Fuel Injector Maintenance. 1. Check tightness and lock of aU nuts which fasten the injector to the engine. 2. Check all fuel lines for tightness and evidence of leakage. 3. Check throttle and mixture control rods and levers for tightness and lock. 4. Remove and clean the injector fuel inlet strainer at the first 25 hour inspection and each SO hour inspection thereafter. Damaged strainer "0" rings should be replaced. Torque strainer to 65·70 inch pounds. b.
Tests prove that gasoline which becomes stale due to prolonged storage absorbs oxygen rapidly. This stale oxidized gasoline acquires a very distinctive odor similar to varnish. causes rapid deterioration of synthetic rubber parts. and also forms a gummy deposit on the internal metal pans. This condition, however. docs not occur during normal operation of the injector where fresh fuel 15 being constantly circulated. 7C·37. Lubrication Of Fuel Injector. a. There is very little need for lubrication of the injector in the field between regular overhauls. However.
the clevis pins used in connection with the throttle and manual mixture control leversshould be checked for freedom of movement and lubricated. if necessary. b. Place a drop of engine grade oil on the end of the throttle shaft in such a manner that it can work into the throttle shaft bushings. 7C·38. Removal Of Fuel Injector. a. Remove the bottom engine cowl. b. Disconnect flexible ducts from compressor discharge box. c. Remove compressor discharge box from injector unit by removing safety wire and cap screws. d. Disconnect throttle and mixture control cables from injector unit. e. Disconnect inlet and outlet fuel lines from injector unit. e. Remove both inboard turbocharger support braces.
g. Remove remainina nuts attaching injector to engine. h. The mixture control cable bracket may be removed' from the injector unit by removing attaching safety wire and screws. POWER PLANT ISSUED: 8/18/72 2 H5