BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 7C-39. Preparation Of Fuel Injector For Shippm,. Any unit taken out of service. or units being retumed for overhaul. must be nushed with preserving oil (Specification MIL.Q-6081, Grade 1010), using the fonowing procedures: a. Remove pluJS and drain all fuel from the injector. If available, apply 10 to 15 psi air pressure to the fuel inlet un~ all fuel is discharged from the injector. b. Replace pluJS and apply flushing oil fdtcred throuah a 100rnicron fllter at 13-15 psi to the injector fuel inlet until oil is discharged from the oudet. c. Replace fuel inlet shipping plq. CAUTION Do not exceed the above air ptaSW't as internal damaJe to the injector may result.

d. After filling widl preservative oil, the injector should be protected from dust and dirt and given such protection against moisture as climatic conditions at the point of storace require. In most cases, storing the unit in a dry area win be sufficient. e. 1f the unit is to be stored near or shipped over salt water, the following precautions should be observed: 1. Spray the exterior of the injector with an approved preservative oil. 2. Pack in a dustproof container, wrap the conumer with moiSture and vapor-proof material and seal. Pack the wrapped unit in a suiuble shipping cue. Pack a on~balf pound baa of silica gel crystals in the dustproof container with injector.

The baa must not touch the injector. CAUTION Extreme caution should be exercised when handling or workin, around the injector to prevent oil or fuel hom entering the air scctions of the injector. As explained previously, dam. to the air diaphrapn will result. Fluid can euily enter the air section of the injector through the impact tubes or the annular groove around the venturi. For this reuon, a protective plate should be installed on the scoop mounting flanse when performing routine maintenance on the engine. Such as washing down the engine and air scoop, servicing the air falter (surplus oil on the element), or when injecting preservative into the engine prior to storing or shipping.

7C-40. Preparation Of Fuel Injector For SCIYicc. Fuel injectors that have been prepared for storlie should undergo the foUowing procedures before being placed in service. a. Remove and clean the fuel inlet strainer uscmbly and reinsuU. b. Inject clean fuel into the fuel inlet connection with the fuel ouden uncapped until clean fuel flows from the outlets. Do not exceed 15 psi inlet pressure. POWER PLANT ISSUED: II18n2 2 "6