BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

U4 PIPER COMANCHE SERVICE MANUAL FIGURE 7e·la. ROTOR HOLDING TOOL INSTALLED FIGURE lC-l1. T1MING KIT INSTALLED 1. The retard conract assembly is adjusred co open a predetermined number of degrees after the main contact assembly opens. The dqree of mard for any particu1ar IDIpctO is scamped in the bottom of the breaker compatmleJu. c. The retard conuct wembly of the dual-braker mapetos may be timed II foUows: 2. Locate the exact point of maiD contact: usembly openiaJ and set the 11-31-409 Poincer Assembly over the 0 mark Oil the 11-3693 Ti.alinc Plate Asser.Ibly. Tum rounn, rnapet in the direction of normal rotation until pointer indexa with the dqrec of mari.

TiBhten adjult'inl knob of 11-8465 Holdinl Tool and set reu:d contaCt UlCmbly co ju.st opa. within ... f ..cf. Tilhtcn Rearin, screws co 20.26 inch poullds. Loosen adjustiq leaob of holdu., cool and tum rotuint mapct until cam foUower is on high pOint of cam lobe. Contact: cleuucc shill be 0.016 t 0.006 inch. If dimension is not within limits. re-adjust coneact assembly and recheck to be sure chat poina will open within retard degree tolerance. Remove the 11-8150-1 Tilnint Kit and twO sruds from the mapcto. d. If the distributor block WII not removed from the houu" the internal timinl may be checked by cumin.

the maencto in the I'lOmW rotation to number one fll'inl position (keyway up and main points just openinJ). At this position. the reference line on the distributor block should line up between the L and LB marks on the Jftt. On sinIle contact mqneros the line should favor the L mark and on the dual contact tnqDCEOS the line should favor the LB mark. if possible. e. If the disaibutor block wu removed from the housinl. the distributor ,ear w,nment and internal check may be accomplished as foUows: 1. Tum rotuinJ mapet in direction of rOtacion until it is located in firing position (keyway up lnd main points just openinl).

TiJhten adjustinl knob of 11-8465 Rotor Holding TooL Apply l light coatint of Bendix Grease PIN 10.27165 to teeth of distributor lcu. if needed, The large distributor gear incorporates four timinl marks. L and LB for left hand rotarion and R and RB for right band rotation. 2. With dismbutor par assembled to block. rum ,ear WltU raised rib on block lines up between the L and LB marks. Assemble block and par iDto housing. meshing the distributor ~ to!mer. For the dua.! ccnuce assembly mapcto. distributor block rib must aIipI between painted marles. However. the rtb should favor the LB mark. if possible. (Reier to Figure 7C-U.) On the sLnlle COftUct magneto the rib should favor :he L marx.

POWER PLANT ISSUED: 8118n2 2 H14