BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL CAUTION :'t1ake certain the sencier resistor is connected to the proper side of the gauge. (b) Connect a 14-volt power supply to tile electrical system of ttw airplane. (C) Operate the power supply and ascertain tbe laup indicates one-half full. (d) Repeat the procedure Ilailll a 3D-obm rHiator which should cauae the laule to indicate fllil. (e) If the laqe does eet iadicate properly, it should be ~placed. 8-10b. Re .. o.ol Of Fuol Send.,. a. Remove screws attachinc the oval cover plate to the top of the wiq. b. Disconnect electrical leads from the sender wt. c. Remove screws and ... hem auachinlsender to moatiq plate and ~tIlove sender. 8-1Oc.

Instoll.tion Of Fuel Se.,. a. Place the sender unit Iuket on mountiq plate aad iutall Hader. b. Secme sender to mDW'ltinC plate with washers and screws. e. Connect electrical lnds to sender. d. Install cover plate and secure with screws. CAUTIOH No repairs are to be made on the radius of a cell or in the fittinl area of a cell. Cells with such damep are to be returned to the facrory for repairs. So damapd ar .. s such as CIlts and tears larger than 1 inch are to be repaired in the field. a. Outside the Cell. 1. Use a piece of synthetic rubber coated fabric (U.S. Rubber Co. 5200 outside repair material) large enCNlh to cover damaCe at least 2 inches from cut in any direction.

Buff this material lilhtlyalld thorolllhly with fine emery eloth(l80 lrit) and .ash with :\1ethyl Ethyl Ketone solution (U.S. Rllbber Co. 3339) to remove buffinl dust. 2. Cement buffed side of patch with two coats of U.S. Rubber Co. 3230 cement or ~inne­ Sota Minin& Co. EC-678. Allow each coat to dry 10 to IS minutes. 3. Buff cell area to be patched lilhtly and thorouchly with fine emery cloth and wash 'Nith 3339 solunen to remove buffinl dust. 4. Cement buffed area with two coatS of U.S. Rubber Co. 3230 or ~innesota }tininl Co. EC·678 cement. Allow each coat to dry 10 to IS minutes. 3. Freshen cemented area of patch and cemented area of cell with 3339 Solution. 6. While still tacky.

apply edge of patch. to edCe of cemented area on the cell. With a REVISED: 4/10/81 FUEL SYSTEM 2 Jl