PIPER COMANCHE SERVICE MANUAL c. Short circ\lits in the &l'DatuN are located by liS. of powler. When the anaature is revolved in the growler, with. stHl !IItrlP such ... hllCk w blade b.ld .bove it, the blade will vibrate above the area of the armature core in wbicb the short is located. Copper or brub dut ill the slots between the cOlllmutator b.rs solHtiIua c .... sbarte betwHt2 ben which CaD be eliminated by cleaninl out the slots. SborQ at ero.a-oven of the coils at the core nd CaD oftn be ellai· n.ted by bendilliwitft sliptly md reiAsu1.tiIlc the e~ed bare wire. d. Grounds in the armature .e detected by use of a test 1_, _d tnt poiDa.
If the l_p Hehts when one tnt point ia placed OIl the commutator with the other point on the core or shaft, the anDature is lfOunded. Grounds OCCUt .. a result of insulation taiha", wbieb i. often broupt on by overloadinl and consequent overheatinl of tbe pnerator. Repairs cu aometimn be made if pound. are at con nda (where coUa cOllIe oat of slots) by placiDl iuulaUDcstriDS betw.-n cote and coil which b .. IlOunded. 9-19. Poloriain, Gen ... ator. Aft.r a pnerator haa been ,.,.ired and reiaatalled or at any time after a e.Qerator baa been t.sted. it must be repolariDd to lIlake aure that it haa the correct polarity with r.s9ect to the battery it is to charae.
Failure to repolarin the pnerator ID.y reault in bumed relay contact points. a run-dOWD battery and pouibly aerious d.lIlace to the tenerator itself. The procedure to foilow in conectillC paHator polar ty depeads upon the pnerator-recu- lator wirine circuits; that is. whether the lenerator field ia intem.lly pounded or is arounded throueh the relUlator. 9-20. Generotor Se,vice Telt s,.cificetioftl. Delc~Remy specific.tiOGa for 12 volt .. erators instaned as standard equipment on the PA·24-180 ud PA·24-2SO .ircraft are as foUo.s: C.ld Output: Cold output data appliea to pneratora at 80 depees F. and with bnlshes w.ll seated.
Variations in temperature and bnash seatinl u well as the condition of the p"8rator may cause deviations of 100 R.P.M. or more from rated speed. Hot Output: Hot output is maximum output u controlled by current regulator. ELECTRICAL SYSTEM ISSUED: 8/18/72 3 A20 Generator 1101900 1101915 Oelco-Remy, Ref. Service Bulletin 1o.lSO 10.150 Brush Sprine Tension 24 oz. 24 oz. Field Cllrrent (80· F) Amps Volts 1.62 - 1.72 12 1.62 - 1.n 12 Cold Output Amps Volts Approx. R.P.~. 3S 14.0 3100 50 14 3960