PIPER COMANCHE SERVICE MANUAL IJOtNT OPINING FIGURE 9.10. CUTOUT RELAY POINT OPENING CHECK AND ADJUSTMENT FIGURE 9·9. CUTOUT RELAY AIR GAP CHECK AND ADJUSTMENT CUrrent flow to the required amOUDt. Allow senerltor to operate at this speed and current flow for is minutes with resulator cover in illaee in order to brine the voltace telUlator to operatic, temperatW'e. e. Cycle the &enerltor by either methad listed in Step "Fixed Resistance ~ethod" of "Voltap Settin," proeedure. I, ~ote the themometft recin, and seleet the "Normal Ranle" of volt ... for this tempera- ture as listed in spec:ificaticns paraCraph 9-4]. g. Note the voltmeter readiul with regulatot cover in place. h.
Adjust voltale rellllatar .. required as described in Step(h) of "Fixed Resistance Method" of "Voltace Sertina Procedure." In usmc the v_iable resistanee methocl. it is necessary to re· adjust the variable resistance after each volta .. adjustment to uaure that 8-10 ampe~s are HowinS. Cycle generator after each adjustment before re-Sincvolta,e relulator settina wlth cover in place. 9-34. Ciltout Relay. The eutaat relay requires three_ cheeks and adjustments: air aap. point openin,. and elo'inc volta The air liP and point openinC adjustments must be made with the battery disconnec:ted. a.
Air Gap - Place fmlers en umatlUe directly above core and move Irmature down until points just close and then measure air sap between armature and center of core (Filllte 9--9). On multiple eattaet paint relays. make sure that all points close I imultaneously . If they do not, bend spring fineer so they do. To adjust air lap. loosen two screws at the back of relay and :aise or lower ~he arm.ture as required. Tishten screws after adjustment. b. Point apeninc - Check point Op8rtUtC and adjust by bendinl the upper armature stop (Figure 9-10). c. Closing Voltaee - Connect rel\11.tor to propet lenerator and battery. Connect voltmeter berween the regulator "GEN" terminal and around (Filure 9-11).
:\tethod 1 - Slowly increase &enerator speed and note relay closinl voltale. Decrease ELECTRICAL SYSTEM ISSUED: 8/18/72 3 83