PIPER COMANCHE SERVICE M,lNUAL aenerator speed and make sur. "the cutout relay points q»en. REGULATOR (C) VARIABLE )1( RESISTANCE :vIethod 2 - ~ake connections as in Step (c), hut in addition add a variable resistor connected into the field circuit (Fipre ~11). Use a 2S ohm-25 watt resister. Operate pn- eratot at medium speed with variable resistance turnlld 811 in. Slowly decrease (tum out) the resistance until cutout relay points clc:.e. I, II ~ote c:10linl voltage. With cover in plaee slowly increase (turn in) resi'tllllce to make sure points open. d. Adjust cll»inC voltace by cumina ad- jUStini screw (Figure 9-12).
Tum screw clock- wise to increase set tine and cout1ter-elockwi to decease settini. VOLTMETER GENERATOR 9-35. Current R.gulator. Two checks aad adjustments are required Oft the current rep- later: air aap and current senina. Air Gap - Cheek and adjust in exactly the .ame lUftIler as for the volta.e reaulator. Clment Settina - Current replator Mttiftl on currem tel'llaton havina temperature com- pensation should be checked by the followiDll'Ilethod: IIIGURI9·11. CHECkiNG CUTOUT RELAY' CLOSING VOLTAGE Load ~ethod- a. Connect ammeter into cb_lin. circuit. as in Fipre ~13. b. Turn on all aeeessory load (lichts. rlNiio.
etc.) aracl COlUlect an additional load across the battery (such as a carbon pile or bend of lipts) so as to drop tbe system volta.e approximately one volt below the voltap replator Settinl. c. Operate pnerator at specified s'P"d for 15 minutes with cove: in place. (This estaba lishes ot:teratina temperature; see par_eraphs (c) and (d) in General Instructions.) If current regulater is not temperature-eompensated. dis- regard 15 minute warm-up period. d. Cyc~e lenerator and note current .etting. e. Adjust in same milliner as described for tlie \'olta,e recuiater (Fieur. 9-6).
ADJUsnNG SCflEW (TURN TO ADJUST CLOSING VOLTAGE Jumper L.ud ~ethod - (Use only for cur- reftt regulaters without temperature compen- unon.) a. Connec~ ammeter into charline circuit. as in Filure ~14. ~. Connect jumper lead acroSs voltace regulatcr ;:Joints, as in Fieure 9014. c. Turn on all lights and accessories er load battery as in (b) under Load Methcx:l.. d. Operate lenerator at specified speed FIGURE 9.12. ADJUSTMENT OF CUTOUT RELAY CLOSING VOLT AG E ELECTRICAL SYSTEM ISSUED: 8/18172 3 84