BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL , .-.11( -- roumrr ~ FIGURE 9.13. CHECKING CURRENT REGULATOR. LOAD METHOD FIGURE 9·1 ... CHECKING CURRENT LEAD METHOD. JUMPER LEAD METHOD and note current setting. e. Adjust in same manner _ desc:ribed for the volta. replator (Filure 9-6). 9-36. Repair Section. 9-37. Regulotor Spring Replacelllent. a. If it Decornes necessary to replace the spiral sprina on either the current or voltage regu- lator unit. the new spring should first be hooked on the lower sprilll support alld then stretched up until it can be hooked at the upper end.

Stretch the sprilla only by means of a screwdriver blade inserted between the turns (or in a similar marmer) - do nO( pry the spring uno place. as this is likely to bend the sprina support. After ill.tllling a new spring. readjust the unit setting as already described. a. The installatim of radio by-pass condensers on the field terminal of the regulator or ge!l- erator will caUSe the reaulator contact points to burn and oxidize so tbat generator output will be reduced and a run down battery will result. If a condenser is fOWld canneeted to either of these termina Is. discormect the condenser .nd clean the reaulator contact points as previously ~xplained. 9-38. Radio By.Pan C..,c1ense,..

9-39. Regulator Armotur. R.placelllent. a. The armature may be replaced by drilling out the two rivets attaching the ann.ture to the regulator frame. Support the frame to avoid hendinl, center-punch the rivet he.ds. and drill out with a 3,32 inch drill. Attach the new armature with screws. teenuhers. and nuts supplied with the service armature. Assemble screws down so that they will not IroWld alainst cover. ELECTRICAL SYSTEM ISSUED: 8/18/72 3 85