BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PiPeR COMANCHE SERVICE MANUAL • a. When installinl a battery. always make absolutely sure the around polarity of the battery aDd the around polarity of the alter- nator are the same. b. \\'ben connectinl a booster battery. lIIake certaiD to CQftftect the neeltive battery teratilla" toeether .d the poaitive battery ter· minals toaether. c. When connectifte a charter to the battery. cOlUleet the charaer positive lead to the battery poeitive tenniDal and tbe charaer ftela- tive lead to the battery nelative tenninal. d. Never operate the eltenaator on open circuit. Make a.olutely certain all connections in the circuit are secure. e.

00 not short acroas or arouad ally of the terminals OD the alter- nator or Naulator. f. 00 ftot attempt to poluUe the alteIDator. 9-46. T••t And Maintenance Of Alte",at.,. (Delc..R...y) 9-47. Inlpection. Even thouch the Iltemator is constructed to live 10nl periods of troubl..free service, a reaular inspection procedure should be followed to obtain the maximWll life from the alternator. The frequency of inspection is detenained 1arply by the type of operatine coaditions. Hiah speed operation. hiah temperatures, .d dust .d dirt all Utae..e the ..ear of brushes. slip rinas and bearinas. •• At regular intervals.

inspect the tenninals for corro.ioft and IODle connections, and the wirina for frayed insulation. Check the mOWlWlI bolta for tiPtn.u, and the belt for alilftment. proper tension and wear. Belt tension should be adjus* in accotduce with enaine manufacturer's recommendations. When tiahtenina belt tension. apply pr.ssure alainst the stator laminations h&- tween the end frames. and not aaainst either end frame. Nois. from an altemator may be callsed by wom or dirty bearinls, loose 1'IlounUna bolts, a loose drive pulley, a defective diode. or a defective stator. 9-48. Disou.",bly. After extll1ded periods of operation.

or at time of ealine overhaul, the alter- nator IDay be removed from the aircraft for a thoroulh inapection and cleanina of all parts The _ ahemator consists of four main components - tha two end frames, the stator and the rotor. To disassemble the altamator, take out the (Gilt thru·bolts, aDd separate the drive end frame and rotor assembly from the stator assembly by Pryinl apart with III screwdriver at the stator ... slot. A mark will help locate the parts in the same position durin sembly. The fit betweea stator and frame is not tight. and the two can be saparated e..ily. Note that the separation is to !)e :nade bet....n the stator frama and drive eed &ame. After dis sembly.

placa a piece of tape _ over the slip rina end frame bearing to prevent entry of dirt and other foreip material. and also place a piece of tape over the sbaft on the slip tinC end. U brush.s are to be re--used. clean with a soit dry cloth. CAUTION Use pressure sensitive tape and not friction tape which would leave III gummy deposit on the shaft. • ELECTRICAL SYSTEM ISSUED: 8111/72 3 89