BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL IIUSH AND TlIMINA.. ASIIM ... Y --'"~=::;..;;: ACJfOR MOUNTING LUG STATOR ASSIMII,Y 'IGURE '.16. CROSS SECTIONAL VIEW Of ALTERMATOR To remove the drive end frame from the totor, place the rotor in a vise and tighten only enoueh to permit removal of the shaft nut. CAUTION Avoid excessive tiahtening as this may cauae distortion of the rotor. Remove the shaft nut, .. alher, puUey, fan, and the collar, and then separate the drive end frame from the rotor shaft. 9-49. Checks. a. Rotor Checks - The rotor may be checked electrically for arounded, open, or short circuited field coils.

To check for grounds, COMect a ll~volt test lamp or an ohmmeterfrom either slip ring to the rotor shaft or to the rotor poles. If the lamp lichts. or if the ohmmeter reading is low, the field winding is Founded (FilUre 9-1i). To check for opens, connect the test lamp or ohmmeter to e.ch slip ring. If the lamp fails to light. or if the ohmmeter reading is hip (infinite), the windine is open (Fieure 9--1i). The winding is ehecked for short·eircuits by connecdne a battery and ammeter in series with the edees of the two slip rines. Note the ammeter reading and refer to Delco-Remy Service paralf' ph 9-57 for specifications. An ammeter readine above the specified value indicates short~ windincs.

An altemate lIlethod is to check the resistance of the field by connecting an ohmmeter to the two slip rinp (Fieure 9-17). If the resistance reading is below the specified value. the winding is shorted. The specified resistance value can be determined by dividina the voltage by the current liven in paraeraph 9-5;. 1Ј the rotor is not defective. and the altemator fails to supply rated output when checked as covered in the section entitled Checkinl Altemator Output, the trouble is in the stator or ELECTRICAL SYSTEM ISSUED: 8/18/72 3 810