BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL b. Stator Checks - To ch.ck the stator wiadiA,s, remove all three stator lead attachin, nuts (Fiaun 9-18). and th.a .. parat. the stator .. sembly &om the ead fr.... The fit between rectifyina diades. Itstor frame IIld end frame is not tiaht. and the two can be .. pu.ted euUy. The Itator willdilllS may be cheeked with I lID-volt test l .. p or III ohmmet.r. If the lamp Hltns. or if the meter readinl is low when cocmected from any stator Ie.:! to the f,llllle. the willdinlS an pounded. If the lamp fails to liaht. or if lIleter readiDl is hith when suee ... ively connected between each pair of stator leads.

the windines are open (FilUre "..-.., I ,-I ~ OHMMETIJI lOt SHOITS ANO 0l'INI1 A short eircuit ill the stltor windinls is difficult to locate without laborato~ test eqUip- ment due to the tow resistance of the windinls. However, if ,U other electrical checks are normal and the lenerator fails to supply rated output. ahorted atator wmdinp are indicated. e. Diode Cheeks - Each diode may be checked electrically for a sborted or open condition. Anyone of the methods outlined below may be used. Ohmmeter Method: One method ofchecking diodes is to u.e an ordinary ohmmetercommonly found in service stations. The lowest ranle scale on the ohmmeter should be used.

and the ohm~ meter should have a IV, volt cell. To determine the cell voltllp. tum the selector to the lowest scale. and then connect the ohmmeter lead. to a voltmeter. The voltmeter will indicate the cell voltace. 9-19). FIGURE 9.11. CHECKING ROTOR t_ .. _ SlUSH HOLDEI ASSlMSLT ~ ~ f': 1f:2,J L r I I I I / / ' "/ ; ~ I (~ ''---..d oMMiiiII ,--- ~ LEAD AnACHING NUTS ~' :=;j FIGURE '.18. SLIP RING El"ID FRAME FIGURE 9.19. CHECKING STATOR ELECTRICAL SYSTEM ISSUED: 8/18/72 3 811