PIPER COMANCHE SERVICE MANUAL cavities. Use a pin or a piece of wire. as shown in Figure 9-27n. to hold the brushes in the holder during assembly. Remove the pin after the brush holder retaining screws have been tightened. Make a continuity check to be sure the brushes are seated against the slip rings. d. Drjye Pulley: Torque the drive pllUey ntta,iniq lUIt to 35 foot pollllds. e. Ventilation: The 8400 series Wlits use a sHIl rinl end coYer that bas a ht»e tYl)e eenaee- t.ion for ait pre.sure ventilation. Remove this cover wben bench tntire the alternator. 9-611. Alt.r"oto, S.rviu T t S,.clficnlo"..
Ptestolite specifications for the 12.yolt alter- nator installed as standard equillment on PA·24 aifllla.s are as follows: i Alternator :\foclel ALX8403 , I 12-volts I 70 IJIII'8fe' I I Voltale Rated Output Ground Polarity Nelative Rotation Bi-Directioaal Rotor: Current Draw (77' F) Resistan:e (77' F) 2.9 to 3.3 am~ ~ 12."volts 3.7 to 4.1 oh_ ELECTRICAL SYSTEM ISSUED: 8/18n2 3 C5 Output Test (77 0 F): Volts Amperes Output Field Amperes Alternator RP~ 13.0 14.2 10.0 i1.5 2.85 3.15 li80 min. sooo min.