PIPER COMANCHE SERVICE MANUAL 9-61n. Retulotor Com,.ne"t Alternator output voltap ~an. within the limits of the desien capability of the alternator. be controlled by properly varyiq the averale level of currant fiow in the rotor windinl and tht Pt..toUte full electronic lolid Itate repl.tor is ... 11 suited for this purpo... The Pr.toUte alternator. due to its desiln. bas lelf ..lilllitiftl current characteristics and needs no cunent .. limitinl IUlit in the replator. a. Transistor: The transistor is an electronic ,witch which can turn on and turn od the flow of current in an electric circuit. It hallO mechanical or lDOvilli pens to we.r out. b. Rectifier Diode:
The rectifier diode will pal am_at in one direction only (forward direction); and in this respect. it mey be compared to. cae· .. y check valva. c. Zener Diode: The Zener diode. ill addition to ,. .. iftl cunent in the forward direction. will pass current in the reverse dilWCtion only when a particular val.... of volta .. is applied in the reverse direction. It is this Zener action whicb _ke. it adaptable for use as a voltace sensinl device in the recwator. d. Resistor: The resistor is a device which i. l15ed to limit current now. 9-610. Operation Of Rot.letor. (Refer to F iCure 9·27p.) a. When the alternator switc::h is turned on.
attery voltap is .pplied to the "I" tetrllinal of the relulator. b. The npn (IWlative.poaitive.cwcative) porer trallli.tor. T3. i. turned on by cumtnt flow from the ianition terminal tbrouah R6 and the collector emitter jWlCtion of T2 throuCh 02 thtoulh the base emitter junction of T3 to &found. c. Whenever the power tranai.tor. T3. i. on (T2 is also on aad T1 is off). current will flow from the ilnition tetrllinal tbrouCh the field winclinl. thtoulh the collector emitter of T3 to cround. d. With the ignition switch on. current will flow from the 'ttl termin.l rel'llator Cround throush a voltage dividinc network cOMistinl of R1. R2 aad Pl.
nul network determines the system operatinc voltale relative to the Zener diode. Zl. reverse conduetiftl volta ... e. Whe:\ the system voltap connected to "t" terminal eache. a value at which the Zener diode connected to the divider network conducts. current will now from the "I" teruunal through R1 through Z1 and throuah tt. bue emitter junction of T1 to &found. This causes the collector emmer junction of T1 to conduct which diverts the ba.e cunent of T2 flowinl from "I" termInal throuch R4 to cround, turninc off T2 which tums off T3. de~nerlizinc the rotor wincline; :hen. when the alternator output voltale falb to a value which perlllits Zl to cease conduction.
T1 will turn off which turns on T2 and T3. re4nerCizinc the rotor windine. f. This sequence is performed so rapidly that the rotor curNnt avera.e appears as a value usually Less than fwl rotor current dependinc on rotor RPM and system load connected. a. Each time the power transistor. T3. is turned off. current fiow in the rotor windina is redl,lced. This causes the rotor macnetic field to collapse whieh would aenerate hiCh voltage at the power transistor. T3. if a path were not prOVided so that the field current can decay at a slower rate. The field suppression diode. 01. prOVides this path. thus protecting the system and regulator from possible damace. h.
Tempera~ure compen.ation is flat which means the reculator will hold the alternator out- Pl,lt voltage constant with temperature inczease or decr after initial warm..up. i . The Prestolite solid stat. relulator uses three npn silicon transistors. ELECTRICAL SYS~EM ISSUED: 8/18/72 3 C6