PIPER COMANCHE SERVICE MANUAL 9-'78. Ov.rhaul. U dUMg the above inspectiCll any indication of st..cine motor difficulty is noted. the SUrting raotor should be remond from the enaine for cleanifte and Npair. 9-'79. RefttOҐal. To remove the startine motor frOal the enliDe, first disconnect the lI'ound cable from the bettery post to prevent short eireuitiftl. Discoanect the Iud from the starting motor terminal, then take out the 1D000ting bolts. The lIIoter can then be lifted off and taken to the bench for overhaul. 9-80. Dilu.e ... 1 r- a. Remove the frame screws frem the cDlllmutator end hem and pull end h.,d and armature from frame.
Lift the brushes and lock in elevated pc*itioD with brush sprinls. Use a puller to re- move the end head from the armature. U.e special bearinC puller to remove the sealed ball beMrinl from the armature shaft. b. Remove the frame serews that secure the par houinC to the frame, Remove bolts and nuts holding the par houainl to the pinion bausinc and sep .. te the two WlitS. Pull Bendix shaft from pinion housinl, Do not loae'the .t .. l spacer that i. located Oft the pinion end of the shait. Remove reduction lear, woodruff key and .teel .pacer from shah. c. Tum the Bendix pinion until it locks in the extended po.ition. Locate "spirol" pin and use a punch to remove. SUd.
drive assembly off the shaft. Do not attempt to disassemble the drive and do not dip it in cleaninc solvent. d. To remove the roller bearincs from the par heusinl, u.e an arbor press and the correct bearing arbor. DO NOT HA."dMER OUT. Each part should be cleaned and inspected for excessIVe wear or damage. Searinls should be checked for proper clearance and evidence of touahness or lalling. Oil and dirt should be removed from Wlulation and the conditiCll of the insulation. checked. 9-81. Brulh... Check the brushes to see that they slide freely in their holders and make full contact on the commutator. If worn to half their oricinal lencth or Ie .. , they should be replaced. 9-82. Armature. a.
Check the commutater for uneven wear. excessive puine or evidence of excessive arcing. If only sliChtly dirty, &lueci or discolored, the COllllDutator can be cleaned with 00 or 000 sand- paper. If the commutator is rOllah or worn, it should be turned iD a latbe. Refer to Fil\lre 9·29b. The armature shaft should be inspected for roup bearial sudac:e. and rOUlh or damaged splines. b. To test the armature for crounds, a set of test probes connected in seri.s with a llQ-volt light should be used. Touch one probe to a commutator see_nt and the other to the armature core. If the test lamp lichts. the armature i. Ctollftded cd should be replaced. c. To test for shotted armature coil., a Itowler i.
used. (Refer to Fipte 9-291:.) The arma- ture is pllCed on the crowler and slowly rotated by hand while a steel strip is held over the COM 50 that it passes over each armature core sl«. If a coil is shorted. the steel sttip will vibrate. d. A quick check for opens can be made by inspec:tinC the tramnl edge (in directlon of ro- tation) of the commutator segments for excessive discoloration. This condition indicates an. open cireui«. ELECTRICAL SYSTEM ISSUED: 8/18/72 3 C16