PIPER COMANCHE SERVICE MANUAL ~~!~I i'NI~WiIami SWITCH CARlON PILE I '- -M;jRiOouU1N=D)-~==!l_~ BATTERY GROUND -STARTING MOTOR FIGURE 9-29.. Mo-LOAD TIST HOOKUP FIGURI9-29f. STALL-TORQUE HOOKUP play should be .005 to .050 of en iDch. b. New bn.Jahes should be properly .. ated whe" ~:IIta11iDlby wrappiDl a .trip of 00 sandpaper arcuttd the commutator (With the .8Ildinc sid. out) 1.25 to 1.50 tilDe. auimum. Drop brushes on sandpaper covered CClllllDutatcr .nd tum the umaNre .lowly ill the diNCtion of rotatien. Dust should be blown out of the 1lI0tor after sandine. MOTE The .priDe tensien is 32 to 40 ounc .. with new brushes. Thi.
ten- sion is lIIe ured with the selle hooked WIder the brush sprine near the brush and the :eadinl i. taken at rient lillie. to the line of force exerted by th_ brush spril'll. c. Check the po.ition of the pinion to be sur. the unit wil1.mah properly with the flywheel rinl lear. See specifications for unit fot COrNet dimensions. Refer to P.ralta"h 9-90. 9-38. B.nch T.,tl. a. After the ItartinlllIotor is r .... embl.d, it should be t .. ted to He that the ng.load current at a certain volta. ia within specification. _ liven i.D par_paph 9-90. To mat. this test. eea- nect as shown in FiCUnt 9-291. If curtent is too bilh.
eh-ek the besriDl aUlnment and end play to make sure there is no bindinc or interfetencer. T .. o or three sharp ras- on the fr ame with a raw- hide hamlller will oftell help to alien the bearinp and f~ the armature. b. If no difficulty is indicated in the above telt, a ItaU torque test may be made to see if the starting motor is producillg its rated crankinl po .... M.ke test connections as shown in F i g\lfe 9-29f. c. If torque and current .e net wit:bin specificatioM, cbeck the seatinl ol the brushes and !ntemal connectiOllS for hip resistance. If the.e checkll are made and found to be in IOod order. replace frame and field assembly end retest starter. EL.ECTRICAL SYSTEM ISSUED:
8/18/72 3 C1S BATTERY