BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVlCE MANt"AL 9-99. Removal And Installation Of Battery. (PA-24-260. Serial Nos. 24-4~47. 24·4300 to 24-.r:-:2. 24-47~4 to 24.4R03 inc l.) The battery is located in the engine compartment at the lower right side of the firewall. The banery may be removed by the following procedure: a Open the right CO" I panel. b. Rernove the battery box cover from the box by removing the cover and box retainer rod at the right side of the box. Raise the cover enough to allow the box to be removed. c. Disconnect the battery cables. ~OTE Always remove the ground cable first and install last to prevent accidental short circuiting or arcing. d.

Slide the box with battery to the right and remove. e. The battery may be installed in reverse order of removal. 9-100, Batter~' Box Corrosion Prevention. The battery box should be checked for spilled electrolyte or corrosion at each 50 hour inspection or at least every 30 days. whichever comes first. Should this be round in the box. on the terminals or around the battery. the battery should be removed and both the box and battery cleaned by the following procedure: a. Open the drain clamp at the bottom of the battery box or with the box removed. drain off any electrolvte that mav have overflowed into the box. b' Clean the box and battery.

Corrosion effects may be neutralized by applying a solution of baking soda and water mixed to a consistency of thin cream. The application of this mixture should be applied until all bubbling action has ceased. CAl'TIO~ Do not allow soda solution to enter battery. c. Rinse the battery and box with clean water and dry. d. A~ necessary. paint the battery box with an acid resistant paint. Allow paint to dry thoroughly. e. If installed. close the battery box drain tube clamp. f. Reinstall the battery. 9-101. Checking Electrical Switches And Circuit Breakers. Electrical switches and circuit breakers. located on the lower portion of the instrument panel.

control the navigation and instrument lights. landing. lights. electric turn and bank indicator and other electrical components. The circuit breakers automatically break the electrical circuit if an overload is applied to the systems. thus preventing damage to electrical wiring. To reset the circuit breakers. simply push in the buttons. Allow sufficient time for cooling before resetting circuit breakers. The time for resetting circuit breakers may vary considerably. depending on the nature of the overload and the temperature. ISSl'ED: 8/18/72 3C23 ELECTRICAL S"STE~