PIPER COMANCHE SERVICE MANUAL the c:qiJlIlmob. If JY1'O is not rowed and the cqinJ knob is employed, the IYfO is not repositioned in the cue, only me card is Nmec:l. this raults in chedtinl the tyro only in one position ae matter how many badiDp the c:al'd may be let to. CAUTION Permit no oil, grease. pipe compound. or any foreign material to enter ports, prior to installation of fittings. Make sure that all air lines are clean and free of foreign panicles and/or residue before connecting lines to gyro. 1HO&. Gyro Handlin, ADd SbippiDJ. Tbe foUowin, informacioQ applies to all three inch dim:1:ioDa1 gyros and attiaade horizoD u.aumCSltS iDIulled by the factOry or a Piper faekl .emce facility.
Gyro instrumcuts bciDt rcaarDed to the fKtOry aft to be placed in ap~ cont&iDm with all pons properly scaled immediately after ranoval from the aircraft iasuumCSlt panel. The insaument must a1to be accompanied by factory copies of the WIIrUlty md cmiit claim fOnnl. Thae forms and the spcciaJ containers should be available at any Piper Dealer UldIor Disaibutor. Should my I)'TO inIcnlmcnt be rcccivcd by the faC1:Ory i.a aD unapproved cOQuer or if the ports arc DOt 1C&1cd, the warranty will be immediately voided md the inmumat rerumcd to the seder. The iala'umCDt mue be lftlItDed immediately after ranoval from the airc:nft (not to e:zcccd 15 days followial dilcamy of defect). 11·11.
Vacuum System. The vacuum sysmn employed to operate the lYfo iDsaumCSltS is comprised of an engine driven vacuum pump, oil-air separator, vacuum rqulator valve, and the necesary Nbin, to complete the system. On me late model Comanche a dry vacuum pump hu been employed. Whm this type pump is installed the Deedfor the oil1ir separator and the hardware aceaaary for its iDstallacion is eliminated. A kit (7$4 356) is available for installation of the dry vacuum pump on any of the early model Comanches. One vacuum replator valve is incorporated in the system to contrOl vacuum pressure to the JYfo insmameins. Access to thil valve for maintenance and adjustment is ,aiDed throqh the CIlline cowling.
On the cariy modd Comanche, the replator valve wu mounted on the farewall. while me later models have the valve installed on the engine mount aaembly. 11.12. Vacuum Rquiaor Valve RaDovU ADd IDIaJIatiOD. To remove the replator valve in the enJine com pamnent, disconnect the thru lines, remove the mountinJ screws and remove the valve. Install regulator in reverse order Jiven for removal. After iDrtallation chcdt complete ftcuum system for leaks and proper operation. 11-13. AdjuIlmCD'C Of Vacuum RcpWor Val_. To adjust the replator valve, perform the foUowing steps: a. Loosen the lock in, nut or remove the prorective cap from the valve. depcndq on which type is installed. INSTRUMENTS REVISED:
4/10/81 3 F21