Komatsu — BEVEL GEAR SHAFT,HSS,BRAKE

STRUCTURE, FUNCTION AND MAINTENANCE STANDARD BEVEL GEAR SHAFT, HSS, BRAKE Outline Brake The brake is installed specially to brake the machine and connected to the brake inner drum (12). The brake is a wet-type, multiple disc clutch- type, spring force brake. It is driven hydraulically by the brake valve operated with brake pedal. The brake is lubricated forcedly with oil supplied by the power train lubricating oil pump and scav- enging pump. The lubricating oil flows through the paths in the steering case, housing, cage, disc, and plate. While the engine is stopped, even if the brake pedal is not pressed, the back pressure of the brake piston lowers and the brake is "applied".

After the engine is started again, however, as the hydraulic pressure in the circuit rises, the brake is "released". Accordingly, the parking brake must be kept locked. The brake consists of carrier gear (25), inner drum (12) connected to brake hub (5), disc (10) meshed with the inner drum, plate (9), the periphery of which is connected to the brake drum (11) by spline, brake drum (11), piston (7) to press the disc and plate against each other, springs (2) and (3), and cage (6), brake cover (8), and output shaft (1) to support these parts. Brake drum (11) and brake cover (8) are fixed to the steering case.

Output shaft (1) are connected to the brake hub by spline and fixed by stopper (4) in the axial direction. Bevel gear shaft The engine power is transmitted through the torque converter to the transmission. Then, the bevel gear shaft device engages the bevel pinion with the bevel gear to turn the engine power at right angles into the lateral direction and reduce the revolving speed. The bevel pinion and bevel gear of the bevel gear shaft device are spiral bevel gears, which are lubricated with oil splashed by the lubricating oil pump and scavenging pump.

The bevel gear shaft device consists of bevel gear (17) meshed with the bevel pinion, bevel gear shaft (16), bevel gear shaft bearing (18) to support the bevel gear shaft, and bevel gear shaft cage (14). HSS The HSS (hydrostatic steering systems) consists of the transfer unit to reverse the revolution direction of the HSS motor and transmit it to gear A (13) and the planetary gear unit to increase or decrease the input for ring gear (22) and gear A (13) and output it to carrier (25). The turning direction of the machine is changed by stopping or reversing the revolution of the HSS motor.

The transfer unit employs a spur gear speed reduction mechanism and is lubricated with oil splashed by the scavenging pump and lubricat- ing oil pump. The planetary gear unit is lubricated forcedly with oil supplied by the scavenging pump and lubri- cating oil pump. The transfer unit consists of pinion (27) con- nected to the HSS motor by spline, gear D (26) meshed with the pinion, gear C (22) meshed with gear D, gear B (15) connected to shaft (19), gear A (13) supported by the bearing on the bevel gear shaft and meshed with gears B (15) and D (26), and cover to support these parts.

The planetary gear unit consists of gear A (13), planet pinion (21), planet shaft (23), hub (24) connected to the bevel gear shaft and ring gear (22) by spline, and carrier (25) connected to brake inner drum (12). D85EX-15 10-77