TESTING AND ADJUSTING STANDARD VALUE TABLE FOR CHASSIS 20-6 D85EX-15 (2) Machine model D85EX, PX-15 Category Item Measurement conditions Unit Standard value for new machine Service limit value Work equipment Work equipment speed Blade lift • Hydraulic oil temperature: 45 – 55°C • Apply no load to blade. • Between ground level and ris- ing end of blade Raise Low idling sec 8 – 15 20 High idling EX: 2.5 – 4.5 PX: 2.2 – 4.2 5.5 5.2 Lower Low idling 1.0 – 1.7 2.2 High idling 1.0 – 1.7 2.2 Blade tilt • Hydraulic oil temperature: 45 – 55°C • Apply no load to blade.
• Between left tilt end and right tilt end Left tilt Low idling sec 3 – 5 7 High idling 2.7 ± 0.5 3.5 Right tilt Low idling 3 – 5 7 High idling 2.2 ± 0.5 3.5 Ripper lift (for EX) • Hydraulic oil temperature: 45 – 55°C • Apply no load to ripper. • Between ground level and ris- ing end of blade Raise Low idling sec 7 – 10 13 High idling 2.5 ± 0.5 4.0 Lower Low idling 2 – 3 4.0 High idling 1.5 ± 0.5 4.0 Time lag Blade • Hydraulic oil temperature: 45 – 55°C • Move lever to stroke end. • Lower blade from max. rising posi- tion and measure time after blade comes in contact with ground until idler is lifted. Low idling sec Max. 8 11 High idling Max.
1.8 2.5 Ripper (for EX) • Hydraulic oil temperature: 45 – 55°C • Move lever to stroke end. • Lower ripper from max. rising posi- tion and measure time after ripper comes in contact with ground until sprocket is lifted. Low idling Max. 6 8 High idling Max. 1.5 2.5