TESTING AND ADJUSTING MEASURING ENGINE SPEED MEASURING ENGINE SPEED 3. Measuring high idling speed 1) Start the engine and set the fuel control dial in the high idling position. 2) Set the PCCS lever and work equipment control lever in neutral and measure the engine speed. a The high idling speed measured in the “Mon- itoring mode” or in the “Pm Clinic auxiliary mode” is the auto-deceleration speed. a When measuring the high idling speed of the engine, use the “Adjustment mode”. Adjustment code: 0007 (Engine decelerator cut mode) a Measure the engine speed under the following condition. Engine water temperature: Within operating range Hydraulic oil temperature:
Within operating range Power train oil temperature: Within operating range 1. Preparation work Turn the starting switch ON and set the monitor panel in the “Monitoring mode” to prepare for measurement of the engine speed. a For the operating method, see “SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)”. Monitoring code: 01000 (Engine speed) 4. Measuring decelerator pedal speed 1) Start the engine and set the fuel control dial in the high idling position. 2) Set the PCCS lever and work equipment control lever in neutral and press the decel- erator pedal and measure the engine speed. 2. Measuring low idling speed 1) Start the engine and set the fuel control dial in the low idling position.
2) Set the PCCS lever and work equipment control lever in neutral and measure the engine speed. D85EX-15 20-105 (1)