Komatsu — MEASURING ENGINE SPEED

TESTING AND ADJUSTING MEASURING ENGINE SPEED 5. Measuring torque converter stall speed 1) Start the engine and set the fuel control dial in the low idling position. 2) Press the brake pedal securely and set the parking brake lever in the FREE position and set the PCCS lever in the FORWARD and 3rd gear speed position. a Before going to the next step, check that the upper display unit of the monitor panel is set in the normal display state and it displays [ F3 ]. a Keep the steering unit in neutral. 3) Press the decelerator pedal and set the fuel control dial in the high idling position. 4) Return the decelerator pedal slowly to stall the torque converter with the engine at high idling. 6.

Torque converter stall + Work equipment relief speed (Full stall speed) 1) Start the engine and set the fuel control dial in the low idling position and raise the ripper to the stroke end. 2) Keep pressing the brake pedal securely and set the parking brake lever in the FREE posi- tion and set the PCCS lever in the FOR- WARD and 3rd gear speed position. a Before going to the next step, check that the upper display unit of the monitor panel is set in the normal display state and it displays [ F3 ]. a Set the steering unit in neutral. 3) Press the decelerator pedal and set the fuel control dial in the high idling position.

4) Return the decelerator pedal slowly to stall the torque converter with the engine at high idling. Keep pressing the brake pedal securely and keep your right foot on the deceler- ator pedal for safety until the work is fin- ished. 5) Just after the power train oil temperature gauge reads the top line of the green range, return the direction of the PCCS lever into neutral. Keep pressing the brake pedal securely and keep your right foot on the deceler- ator pedal for safety until the work is fin- ished. 5) Just after the power train oil temperature gauge reads the top line of the green range, return the direction of the PCCS lever into neutral. 6) Repeat above steps 2) – 5) 3 times.

7) Perform steps 2) – 4) again and measure the engine speed about 5 seconds after the power train oil temperature gauge reads the top line of the green range. a After finishing measurement, return the direction of the PCCS lever into neutral and lower the power train oil temperature with the engine at high idling. 6) Repeat above steps 2) – 5) 3 times. 20-106 D85EX-15 (1)