TESTING AND ADJUSTING MEASURING COMPRESSION PRESSURE 7. Install adapter N2 and connect it to compression gauge N1 . a Leakage can be prevented by applying a lit- tle amount of engine oil to the fitting faces of the adapter and gauge. a Secure the adapter with the injector holder. 10. After finishing measurement, return the removed parts. Injector assembly mounting bolt: 58.8 – 73.5 Nm {6.0 – 7.5 kgm} Fuel high-pressure tube sleeve nut: 39.2 – 49.0 Nm {4.0 – 5.0 kgm} Cylinder head cover mounting bolt: 9.8 ± 1.0 Nm {1.0 ± 0.1 kgm} Air intake connector hose clamp bolt: 6.8 ± 0.49 Nm {69 ± 5 kgcm} Air cleaner air intake hose clamp bolt: 8.8 ± 0.5 Nm {0.9 ± 0.05 kgm} Air cleaner band bolt:
9.8 – 11.76 Nm {1.0 – 1.2 kgm} 8. Disconnect concentrated connector (9) (E21) for the engine. Disconnect the concentrated connector for safety, although the fuel high-pressure tube is disconnected. Cover the connector on the controller side with a vinyl sheet, etc. to prevent electric leakage and grounding fault. 9. Crank the engine with the starting motor and measure the compression pressure. a Measure the pressure when the pointer of the gauge is stabilized. 20-116 D85EX-15 (1)