TESTING AND ADJUSTING MEASURING BLOW-BY PRESSURE MEASURING BLOW-BY PRES- SURE a The blow-by pressure may vary largely with the engine condition. If the measured value is judged abnormal, check for increase of oil consumption, bad exhaust gas color, deterioration of oil, high deterioration speed of oil, etc. which are related to the abnormal blow-by pressure. a Measuring instrument for blow-by pressure a Measure the blow-by pressure under the follow- ing condition. Engine water temperature: Within operating range Power train oil temperature: Within operating range Hydraulic oil temperature: Within operating range 1. Remove the radiator drain cock cover. 2.
Install nozzle [1] of blow-by checker E to blow-by hose (1) and connect them to gauge [2]. 4. After finishing measurement, remove the mea- suring instrument and return the removed parts. 3. Run the engine at high idling, stall the torque converter, and measure the blow-by pressure. a For the procedure for stalling the torque con- verter, see MEASURING ENGINE SPEED. a Normally, the blow-by pressure should be measured while the engine is operated at the rated output. In the field, however, an approximate value can be obtained by stall- ing the torque converter.
a If it is impossible to run the engine at the rated output or stall the torque converter, measure while the engine is running at high idling. The value obtained in this case is about 80% of the blow-by pressure at the rated output. D85EX-15 20-117 (1) Symbol Part No. Name E 799-201-1504 Blow-by kit