Komatsu — BLEEDING AIR FROM FUEL CIRCUIT

TESTING AND ADJUSTING BLEEDING AIR FROM FUEL CIRCUIT 4. Loosen air bleeder (5) of the fuel supply pump and operate priming pump (4) 90 to 100 times. a Continue operating the priming pump until fuel flow out from the bleeder. When fuel comes out, tighten the bleeder, then operate several times until the priming pump becomes stiff. Air bleeder: 4.9 – 6.9 Nm {0.5 – 0.7 kgm} 5. Crank the engine with the starting motor and start the engine. a When the engine is cranked, the air in the high-pressure circuit is automatically bled. a If the engine does not start, the air has prob- ably been not properly bled from the low- pressure circuit, so repeat the procedure from Step 2. D85EX-15 20-123 (1)