Komatsu — ADJUSTING TRANSMISSION SPEED SENSOR

TESTING AND ADJUSTING ADJUSTING TRANSMISSION SPEED SENSOR ADJUSTING TRANSMISSION SPEED SENSOR 6. Taking care of the direction of cover (2), install it and sensor (2) together again to HSS case (4). 1. Remove the fuel tank undercover, and then remove transmission speed sensor (1) and cover (2) together. a Before adjusting transmission speed sensor (1), remove it temporarily and check that its tip is free from a steel chip and a flaw. a Before installing the transmission speed sen- sor, separate sensor (1), cover (2), and lock- nut (3). Surfaces of cover and case: Gasket sealant (LG-5) 7.

After finishing adjustment, set the monitor panel in the "Monitoring display mode" and check that the transmission speed is displayed normally. a For the method of operation, see "Special functions of monitor panel (EMMS)". a Model code: 31400 (Transmission speed) 2. Install cover (2) to HSS case (4) temporarily. a Take care of direction of cover (2). 3. Tighten sensor (1) until its tip touches the tooth tip of gear (5). Threads of sensor: Gasket sealant (LG-5) 4. Return sensor (1) from the above position by the specified angle. a Returning angle of sensor: 1/2 – 1 turn a Adjust clearance a between the sensor tip and gear tooth tip to 0.75 – 1.50 mm. 5.

Remove sensor (1) and cover (2) together and secure them with locknut (3). a Take care that the adjustment angle of the sensor will not change. Nut: 49.0 – 68.6 Nm {5 – 7 kgm} 20-134 D85EX-15 (1)