TESTING AND ADJUSTING ADJUSTING PLAY OF WORK EQUIPMENT PPC VALVE ADJUSTING PLAY OF WORK EQUIPMENT PPC VALVE a The ripper valve is not adjustable. a If the end play of the blade lever is excessive, adjust it with their PPC valves according to the following procedure. Standard play a : 0.5 – 3.0mm at 200mm from revolution cen- ter of lever (in both longitudinal and lateral directions) 1. Remove boot (1). 2. Loosen locknut (2) and turn disc (3) to adjust the play. a Do not move the piston at this time. 3. Fix disc (3) and tighten locknut (2). Locknut: 98 – 127 Nm {10 – 13 kgm} 4. Install boot (1). 20-150 D85EX-15 (1)