Komatsu — TESTING PARTS WHICH CAUSE HYDRAULIC DRIFT OF BLAND AND RIPPER

TESTING AND ADJUSTING TESTING PARTS WHICH CAUSE HYDRAULIC DRIFT OF BLADE AND RIPPER TESTING PARTS WHICH CAUSE HYDRAULIC DRIFT OF BLADE AND RIPPER a If the blade or ripper drifts hydraulically, check to see if the cause is on the cylinder packing side or control valve side according to the following pro- cedure. 1. Set the cylinders to be tested in the following positions and stop the engine. 1) Blade lift cylinder Brace the blade to raise the front side of the machine body. a Since the blade lift cylinder is equipped with a piston valve, do not extend it to the stroke end. 2. Extend the cylinder to be tested with the corre- sponding lever and check its movement.

If the lowering speed is increased, the cylin- der packing is defective. If the lowering speed does not change, the control valve is defective. a If the pressure in the accumulator is lost, run the engine for about 10 seconds to heighten the pressure in the accumulator. [Reference] Reason why the lowering speed is increased when the cylinder packing is the cause of the hydraulic drift: 1) If the machine is set in the above position (where the holding pressure is applied to the bottom side), the oil leaks from the bottom side to the head side.

Since the volume on the head side is less than that on the bottom side by the volume of the rod, the pressure in the head side is increased by the oil flowing in from the bottom side. 2) As the pressure in the head side is increased, it is balanced at a certain level (which depends on the leakage), then the lowering speed is lowered. 3) If the circuit on the head side is opened to the drain circuit by the above operation of the lever (the bottom side is closed by the check valve at this time), the oil on the head side flows in the drain circuit. As a result, the pressure is unbalanced and the lowering speed is increased.

2) Blade tilt cylinder Retract the tilt cylinder to the stroke end and brace the blade to push up the right side of the machine body. 3) Ripper lift cylinder Brace the ripper to push up the rear side of the machine body. D85EX-15 20-151 (1)