TESTING AND ADJUSTING MEASURING INTERNAL LEAKAGE OF WORK EQUIPMENT CYLINDER, BLEEDING AIR FROM WORK EQUIPMENT CYLINDER MEASURING INTERNAL LEAKAGE OF WORK EQUIPMENT CYLINDER BLEEDING AIR FROM WORK EQUIPMENT CYLINDER a Measuring instruments for internal leakage of work equipment cylinder a If the work equipment cylinder is removed and installed or its piping is disconnected and con- nected, bleed air from its circuit according to the following procedure. 1. Run the engine at low idling for about 5 minutes. a Measure the internal leakage of work equipment cylinder under the following condition. Hydraulic oil temperature:
45 – 55°C a Since the blade lift cylinder is equipped with a piston valve, its internal leakage cannot be mea- sured. 2. Running the engine at low idling, extend and retract the cylinder to be bled 4 – 5 times. a Move the piston rod to about 100mm before the stroke end and never relieve the oil. 3. Running the engine at high idling and carry out the operation in 2. 1. Retract the cylinder to be measured to the stroke end and set the machine in the measuring posi- tion. 1) Blade tilt cylinder Tilt the blade to the right end. 2) Ripper lift cylinder Pull out the shank pin and lower the ripper to the end. 4.
Running the engine at low idling, move the cylin- der to the stroke end to relieve the oil. 2. Disconnect hose on the cylinder bottom side and block the hose side with a plug. a Remove the hose cover of the blade tilt cylin- der. Take care not to disconnect the hose on the head side. 3. Run the engine at high idling and apply the relief pressure to the cylinder head side. Blade tilt cylinder: Operate to tilt blade to right. Ripper lift cylinder: Operate to lower ripper. 4. After 30 second, measure leakage in 1 minute. 5. After finishing measurement, return the removed parts. 20-152 D85EX-15 (4) Symbol Part No. Name L Purchased Measuring cylinder