TESTING AND ADJUSTING BLEEDING AIR FROM FAN PUMP BLEEDING AIR FROM FAN PUMP a If the fan pump is removed and installed or its piping is disconnected and connected, bleed air from the pump case according to the following procedure. a Before bleeding air, check that the hydraulic oil level is proper. 1. Remove the floor inspection cover (R.H). 2. Loosen air bleeder (1) and leave it for 15 min- utes. 3. After 15 minutes, run the engine at low idling. 4. After oil flows out of air bleeder (1), tighten air bleeder (1). D85EX-15 20-157 (1)