TESTING AND ADJUSTING TESTING AND ADJUSTING OF OPERATOR’S CAB ii) Adjusting height of latch and striker (1) Tighten the mounting bolt of striker (4) temporarily bolt and close the door 2 – 3 times to align latch (3) and striker (4) with each other. (2) Check the engaging condition of latch (3) and striker (4). (3) Tighten the mounting bolt of striker (4) securely. (4) Open and close the door and check that it is locked and unlocked smoothly. If the door is not locked and unlocked smoothly (If the knob is heavy), perform the adjustment pro- cedure from the first. a Operating effort of knob: 49 ± 19.6 N {5 ± 2 kg} iii) Apply grease (G2-LI) to latch (3).
a If latch (3) is not greased, the knob becomes heavy. Accordingly, apply grease sufficiently. ii) Check the installed height of stopper rub- ber. (Check both sides, 2 pieces on each.) (1) Lock the door open and shake it in the forward and reverse directions to see if it has any play. (2) Check that the operating effort of unlock lever is not heavy. (3) Check that striker (4) does not slant from center (d) of the latch. (4) Check that the latch is not shifted from center (e) of the striker. Normal: Error of " a " must be 0.5 mm or less. 4. Testing open lock Lock the door open and check the relation- ship between the operator’s cab and door. If there is any fault, repair it.
1) Check of condition i) Check the relationship between open lock latch (3) and striker (4) from the direction of B . 2) Adjusting i) Adjusting latch and striker Loosen mounting bolt (7) of striker (4), adjust striker (4) upright, and tighten mounting bolt (7). a Move the door in the opening direc- tion to check the engagement of the latch and striker. 20-162 D85EX-15 (5)