TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS) [11] 1012: Steering lever neutral set This code is used to adjust the steering potenti- ometer neutral position of the PCCS lever. The output signal of steering potentiometer from displayed by voltage on the lower line (Display range: 0 – 5000). Adjustment method: 1) Shift the PCCS lever in the steering neutral position. 2) Set buzzer cancel switch (4) in the [ ] posi- tion and check that the caution buzzer sounds. a Even if this code is turned off, the setting is effective. a This code is not for adjustment of the steering performance, etc. a Even after adjustment, the display of the lower line does not change. [12] 1013:
Steering lever left set This code is used to adjust the maximum left steering potentiometer position of the PCCS lever. The output signal of the steering potentiometer from displayed by voltage on the lower line (Dis- play range: 0 – 5000). Adjustment method: 1) Set the PCCS lever to the left steering stroke end. 2) Set buzzer cancel switch (4) in the [ ] posi- tion and check that the caution buzzer sounds. a Even if this code is turned off, the setting is effective. a This code is not for adjustment of the steer- ing performance, etc. a Even after adjustment, the display of the lower line does not change. 20-186 D85EX-15 (1)