TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS) [13] 1014: Steering lever right set This code is used to adjust the maximum right steering potentiometer position of the PCCS lever. The output signal of steering potentiometer from displayed by voltage on the lower line (Display range: 0 – 5000). Adjustment method: 1) Set the PCCS lever to the right steering stroke end. 2) Set buzzer cancel switch (4) in the [ ] posi- tion and check that the caution buzzer sounds. a Even if this code is turned off, the setting is effective. a This code is not for adjustment of the steer- ing performance, etc. a Even after adjustment, the display of the lower line does not change.
[14] 2222:HSS lever initial current set When the steering start feeling is different by the steering direction, this code is used to adjust the turning radius at the start of steering. The current to drive the HSS EPC solenoid is displayed on the lower line [Display range: –350 (Left end) – 0 – 350 (Right end)]. Adjustment method: 1) Gradually turning the PPC lever to the left or right, display and keep the current to be set. If the lever is turned to the left, the cur- rent becomes negative. If the lever is turned to the right, the cur- rent becomes positive. 2) Set buzzer cancel switch (4) in the [ ] posi- tion and check that the caution buzzer sounds.
a As the set current is increased in the positive or negative direction, the turning radius at the start of steering is decreased (the machine turns more quickly). a The figure at right is an example that the set current for steering to the left is reduced to increase the turning radius. a Even if this code is turned off, the setting is effective. D85EX-15 20-187 (1)