TESTING AND ADJUSTING HANDLING OF HIGH-VOLTAGE CIRCUIT OF ENGINE CONTROLLER, ADJUSTMENT METHOD OF REPLACED CONTROLLER HANDLING OF HIGH-VOLT- AGE CIRCUIT OF ENGINE CONTROLLER ADJUSTMENT METHOD OF REPLACED CONTROLLER a After the machine is assembled or steering and transmission controller is replaced, adjust the system according to the following procedure. If the system is not adjusted, the machine may not operate normally and may move suddenly. Accordingly, be sure to adjust it. a Precautions for replacing a controller: If a controller is replaced, the memory of the oil and filter maintenance mode is reset.
Accord- ingly, take a record of the next replacement peri- ods of the oils and filters. a Precautions for replacing a controller: When replacing a controller, stop the machine in a safe place and turn the starting switch off. The engine controller has a high-voltage circuit (110 – 130V) to drive the fuel injector. This cir- cuit is connected to the wiring harness and con- nectors between the engine controller and fuel injector. a Normally, the engine controller outputs the high voltage to the fuel injector only while the engine is running and stops outputting if the engine stops. 1.
Setting system in service mode Turn the starting switch on and set the monitor panel in the “Adjustment mode” of the service mode. 2. Adjusting steering and transmission control- ler Select steering and transmission controller spec- ification set (0002) and adjust the steering and transmission controller. If you touch the high-voltage circuit directly, you may get an electric shock. To avoid this, observe the following precautions. 1. The following connectors are used in the high- voltage circuit. Engine controller connector: EGC3 Junction connector: E21 Injector connectors: CN1, CN2, CN3, CN4, CN5, CN6 Injector head terminal (in head cover) 2.
When disconnecting or connecting a connector related to the high-voltage circuit, be sure to turn off the starting switch. 3. If a T-adapter is inserted in or connected to a connector related to the high-voltage circuit for troubleshooting, do not start the engine. a You may turn the starting switch to the OFF or ON position but must not turn it to the START position. D85EX-15 20-201 (1)