Komatsu — ADJUSTMENT METHOD OF REPLACED CONTROLLER

TESTING AND ADJUSTING ADJUSTMENT METHOD OF REPLACED CONTROLLER 3. Turning power on again Turn the starting switch off and on, then set the monitor panel in the “Adjustment mode” of the service mode again. 7. Checking error codes 1) Set the monitor panel in the “Electric system error code display mode” of the service mode. 2) See if any error code is being output cur- rently. If any error code is not being output, delete the all error codes. a If any error code is being output, remove its cause by troubleshooting and execute steps 6 and 7 again. 4. Adjusting machine specification Select Machine specification set (0004) and adjust the machine specification.

a Precautions after replacing controller: If any controller is replaced, the service meter in the oil and filter maintenance mode is reset to 0. As a result, the replacement period displayed on the monitor panel may be different from the actual operating hours. To solve this problem, determine the first replacement periods of the oils and filters after the replacement of the con- troller according to the replacement periods recorded before the replacement of the control- ler. 5. Adjusting brake potentiometer Select Brake potentiometer initial set (0005) and adjust the brake potentiometer. 6. Turning power on again Turn the starting switch off and on. 20-202 D85EX-15 (1)