Komatsu — PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM

TESTING AND ADJUSTING PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM 2. Engine controller 1) Remove left console box inspection cover (3). a When carrying out troubleshooting for an electric circuit related to the monitor panel, engine con- troller or steering and transmission controller, expose the related connectors according to the following procedure. 1. Monitor panel 1) Remove cover (1) above the dashboard. 2. Insert or connect T-adapters in or to connec- tors EGC1, EGC2, and EGC3 of engine con- troller (4). a If the connectors cannot be disconnected and connected easily, remove the con- troller from the floor frame.

a Since the connectors are secured with screws, loosen those screws before dis- connecting. a When connecting the connectors again, tighten their screws to the specified torque. 2) Insert or connect T-adapters in or to connec- tors S03 and S04 on the back side of monitor panel (2). Screw: 2.82 Nm {0.288 kgm} D85EX-15 20-203 (1)