Komatsu — PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM

TESTING AND ADJUSTING PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM 3. Steering and transmission controller 1) Remove engine controller a Disconnect connectors (EGC1, EGC2, EGC3) of the engine controller. 2) Insert or connect T-adapters in or to connec- tors STC1, STC2, and STC3 of steering and transmission controller (5). a If the connectors cannot be disconnected and connected easily, remove the con- troller from the floor frame. a Since the connectors are secured with screws, loosen those screws before dis- connecting. a When connecting the connectors again, tighten their screws to the specified torque. Screw: 2.82Nm {0.288kgm} 20-204 D85EX-15 (1)