TROUBLESHOOTING INFORMATION DESCRIBED IN TROUBLESHOOTING LIST INFORMATION DESCRIBED IN TROUBLESHOOTING LIST a The troubleshooting list and related circuit diagram summarize the following information. Understand their contents well to advance troubleshooting.
D85EX-15 20-405 (1) Action code Error code Controller code Trouble Trouble that appeared on machine Panel display Panel display Steering and transmission Contents of trouble State where the monitor panel or controller detects the trouble Action of monitor panel or controller Action to be taken to protect the system and equipment when the monitor panel or controller detects a trouble Problem that appears on machine Problem that appears as an abnormality in the main unit by the action taken by the monitor panel or con- troller (above) Related information Information related to a detected trouble or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Cause by which a trouble is as- sumed to be detected (The order number indicates a serial number, not a priority se- quence.) • Standard value in normal state required to judge the assumed cause (good or not) • Remarks required to judge whether the cause is good • Disconnection in wiring The connector connection is defective or the wiring harness is disconnected.
• Grounding fault A harness not connected to the ground (earth) circuit comes into contact with the ground (earth) circuit. • Defective hot short A harness not connected to the power (24V) circuit comes into contact with the power (24V) circuit. • Defective short A harness of an independent circuit abnormally comes into con- tact with one of another circuit. (1) Method of indicating connector numbers and handling T-junc- tion For troubleshooting, insert or connect the T-junction adapter as shown below unless especially specified. • When “male” or “female” is not indicated for a connector num- ber, disconnect the connector, and insert the T-junction adapt- er in both the male and female.
• When “male” or “female” is indicated for a connector number, disconnect the connector, and insert the T-junction adapter in only either the male or female. (2) Pin number description sequence and tester lead handling For troubleshooting, connect the plus (+) and minus (–) leads as shown below unless especially specified. • Connect the plus (+) lead to a pin or harness indicated in the front. • Connect the minus (–) lead to a pin or harness indicated in the rear. 2 3 4 5