TROUBLESHOOTING ERROR CODE 15SELH ERROR CODE 15SELH (1ST CLUTCH: SEE THE LIST. (LH)) Circuit diagram related to transmission 1st clutch ECM D85EX-15 20-413 (1) Action cod e Error code Controller code Trouble Level 1 clutch: See the list. (LH) (Steering and transmission controller system) CALL E03 15SELH Steering and transmission Contents o trouble f • The fill switch signal is not set off at output to the transmission 1st clutch solenoid circuit. Action of controller • Flashes caution lamp and turns on caution buzzer. • Limits operation of engine and transmission. Problem th appears o machine at • The auto shift down function does not start.
n • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, running is limited to F2 and R2. Related informatio • The input state (ON/OFF) from the 1st clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) n • Method of reproducing error code:
Engine start + F1 or R1 running Possible caus and standard value in norm state Cause Defective 1st clutch fill 1 switch (Internal short) Disconnection in wiring har- es ness (Disconnection in wir- 2 ing or defective contact in al connector) Defective steering and 3 transmission controller Defective hydraulic pres- 4 sure system Standard value in normal state/Remarks on troubleshooting Defective 1st clutch fill switch (Internal short) aPrepare with starting switch OFF, then start the engine for trouble- shooting. F1T (male) PCCS lever Resistance Between (1) – chassis ground Other than F1/R1 Min. 1Mz F1·R1 Max.
1z Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC3 (female) (19) – F1T (female) (1) Resistance Max. 1Mz Defective steering and transmission controller aPrepare with starting switch OFF, then start the engine for trouble- shooting. STC3 PCCS lever Voltage Between (19) – chassis ground Other than F1/R1 20 – 30V F1·R1 Max. 1V Defective hydraulic pres- sure system When no fault is detected in the electric system, the hydraulic pressure system is assumed to be abnormal. Carry out the related troubleshoot- ing (H mode).