Komatsu — ERROR CODE [15SFLH] (2ND CLUTCH:SEE THE LIST.(LH))

TROUBLESHOOTING ERROR CODE 15SFLH ERROR CODE 15SFLH (2ND CLUTCH: SEE THE LIST. (LH)) Circuit diagram related to transmission 2nd clutch ECMV D85EX-15 20-415 (1) Action code Error code C ontroller code Trouble 2nd clutch: See the list. (LH) (Steering and transmission controller system) CALL E03 15SFLH Steering and transmission Contents of trouble • The fill switch signal is not set on at output to the transmission level 2 clutch solenoid circuit. Action of controller • Flashes caution lamp and turns on caution buzzer. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half).

• Once machine is stopped, running is limited to F1 and R1. Related information • The input state (ON/OFF) from the 2nd clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) • Method of reproducing error code:

Engine start + F2 or R2 running Possible cause and standard value in normal state Cause Defective 2nd clutch fill 1 switch (Internal short) Disconnection in wiring har- s ness (Disconnection in wir- 2 ing or defective contact in connector) F Defective steering and 3 transmission controller Defective hydraulic pres- 4 s sure system i Standard value in normal state/Remarks on troubleshooting aPrepare with starting switch OFF, then start the engine for trouble- shooting. F2T (male) PCCS lever Resistance Between (1) – chassis ground Other than F2/R2 Min. 1Mz F2·R2 Max. 1z aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

Wiring harness between STC3 (female) (29) – Re 2T (female) (1) sistance Max. 1Mz aPrepare with starting switch OFF, then start the engine for trouble- shooting. STC3 PCCS lever Voltage Between (29) – chassis ground Other than F2/R2 20 – 30V F2·R2 Max. 1V When no fault is detected in the electric system, the hydraulic pressure ystem is assumed to be abnormal. Carry out the related troubleshoot- ng (H mode).