Komatsu — ERROR CODE [DD12KA] (SHIFT UP SWITCH:DISCONNECTION (KA))

TROUBLESHOOTING ERROR CODE DD12KA ERROR CODE DD12KA (SHIFT UP SWITCH: DISCONNECTION (KA)) D85EX-15 20-479 (1) Action code Error code Controller code Trouble Shift up switch: Disconnection (KA) (Steering and transmission controller system) E02 DD12KA Steering and transmission Contents of trouble • Signals of two systems of shift up switch circuit were turned OFF (OPEN) at the same time. Action of controller • Flashes caution lamp and turns on caution buzzer. • Recognizes that switch is not pressed. Problem that appears on machine • Shift up is not possible. • Auto shift down does not function.

Related information • Of signals of two systems of switch, NO is for operation detection and NC is for error detection. • Input state (ON/OFF) from shift up switch can be checked in monitoring mode. (Code 40905: Steering and transmission controller input signal 1) • Method of reproducing error code: Turn starting switch ON and operate shift up switch. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective shift up switch (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

SFTU (male) Shift up switch OFF (Release) ON (Press) Resistance between (2) – (3) Max. 1z Min. 1Mz Resistance between (2) – (1) Min. 1Mz Max. 1z 2 Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between TMCN1 (female) (12) – SFTU (female) (3) Resistance Max. 1z Wiring harness between TMCN2 (female) (9) – SFTU (female) (1) Resistance Max. 1z Wiring harness between TMCN1 (female) (4) – SFTU (female) (2) Resistance Max.

1z 3 Hot short circuit in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC1 (female) (12) – TL1 (female) (3) with chassis ground Voltage Max. 1V Short circuit of wiring harness between STC1 (female) (9) – TL1 (female) (1) with chassis ground Voltage Max. 1V 4 Defective steering and transmission controller aPrepare with starting switch OFF, turn starting switch ON and carry out troubleshooting. STC1, STC3 Shift up switch OFF (Release) ON (Press) Voltage between STC1 (12) – STC1 (4) Max. 1V 5 – 11V Voltage between STC3 (9) – STC1 (4) 5 – 11V Max. 1V