TROUBLESHOOTING ERROR CODE DGS1KX ERROR CODE DGS1KX (HYDRAULIC OIL TEMPERATURE SENSOR: INPUT SIGNAL IS OUT OF NORMAL RANGE (KX)) Circuit diagram related to hydraulic oil temperature sensor D85EX-15 20-497 (1) Action code Error code Controller cod e Hy Trouble ran draulic oil temperature sensor: Input signal is out of normal ge (KX) (Steering and transmission controller system) — Steering and DGS1KX transmission Contents of • trouble Hydraulic oil temperature sensor signal is out of normal range. Action of • controller Does not take any particular action. Problem that appears on • machine Hydraulic oil temperature gauge of monitor panel may not display normally.
• Related information • Hydraulic oil temperature (temperature) can be checked in monitoring mode. (Code 04401: Hydraulic oil temperature) Method of reproducing error code: Turn starting switch ON or start engine. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective hydraulic oil tem- perature sensor (Internal 1 disconnection or short cir- cuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. SDS (male) Resistance Between (1) – (2) 1k – 50kz Between (1) – chassis ground Min.
1Mz Disconnection in wiring har- ness (Disconnection in wir- 2 ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC1 (female) (14) – SDS (female) (1) Resistance Max. 1z Wiring harness between STC1 (female) (21) – SDS (female) (2) Resistance Max. 1z Short circuit with chassis 3 ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between STC1 (female) (14) – SDS (female) (1) with chassis ground Resistance Min.
1Mz Short circuit with power 4 source in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC1 (female) (14) – SDS (female) (1) with chassis ground Voltage Max. 1V Defective steering and 5 transmission controller aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC1 (female) Resistance Between (14) – (21) 1k – 50kz Between (14) – chassis ground Min. 1Mz