TROUBLESHOOTING ERROR CODE DK40KB ERROR CODE DK40KB (BRAKE POTENTIOMETER: SHORT CIRCUIT (KB)) Circuit diagram related to brake potentiometer 20-518 D85EX-15 (1) Action cod e Error code C ontroller code Trouble Brake potentiometer: Short circuit (KB) (Steering and transmission controller system) CALL E03 DK40KB Steering and transmission Contents o trouble f • Signal voltage of brake potentiometer circuit is below 0.5V or above 4.5V. Action of controller • Flashes caution lamp and turns on caution buzzer. • Does not control with signal of brake potentiometer (Brake can be operated with pedal). • Limits operation of engine and transmission.
Problem th appears o machine at • Brake control performance of brake pedal lowers. n • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. Related information • Input (Voltage) from brake potentiometer can be checked in monitoring mode. (Code 50400: Voltage of brake potentiometer) • Method of reproducing error code: Turn starting switch ON and operate brake pedal.
Possible caus and standard value in norm state Cause Defective 5V sensor power 1 source system Defective brake potentiom- 2 eter (Internal disconnection or short circuit) es al Short circuit with power 3 source in wiring harness (Contact with 24V circuit) Defective steering and 4 transmission controller Standard value in normal state/Remarks on troubleshooting Defective 5V sensor power source system See if error code [DAQ5KK] [DB35KK] is displayed. If it is displayed, carry out troubleshooting for it first. Defective brake potentiom- eter (Internal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
BRK (male) Resistance (A) – (C) 4.0 – 6.0kz (A) – (B) 0.25 – 7.0kz (B) – (C) 0.25 – 7.0kz Short circuit with power source in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC1 (female) (3) – BRK (female) (B) with chassis ground Voltage Max. 1V Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (3) – (B) 0.5 – 4.5V