Komatsu — ERROR CODE [DK56KA] (FORWARD-REVERSE POTENTIOMETER 1 :DISCONNECTION (KA))

TROUBLESHOOTING ERROR CODE DK56KA ERROR CODE DK56KA (FORWARD-REVERSE POTENTIOMETER 1: DISCONNECTION (KA)) D85EX-15 20-521 (5) Action code Error code Controller code Trouble Forward-reverse potentiometer 1: Disconnection (KA) (Steering and transmission controller system) CALL E03 DK56KA Steering and transmission Contents of trouble • Signal voltage of forward-reverse potentiometer 1 system is below 0.5V. Action of controller • Flashes caution lamp and turns on caution buzzer. • Continues controlling with signal of forward-reverse potentiometer 2 system. • Limits operation of engine and transmission.

Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. Related information • Input (Voltage) from forward-reverse potentiometer 1 can be checked in monitoring mode. (Code 50200: Voltage of forward-reverse potentiometer 1) • Method of reproducing error code: Turn starting switch ON and operate PCCS lever (for forward/re- verse travel). Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective 5V sensor power source system See if error code [DAQ5KK] is displayed. If it is displayed, carry out troubleshooting for it first.

2 Defective forward-reverse potentiometer 1 (Internal disconnection or short cir- cuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. TL2 (male) Resistance Between (4) – (1) 3.2kz ± 20% Between (2) – (4) 5.5 – 1.5 kz (Forward – Reverse) Between (2) – (1) 1.5 – 5.5 kz (Forward – Reverse) 3 Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC1 (female) (22) – TL2 (female) (4) Resistance Max. 1z Wiring harness between STC1 (female) (7) – TL2 (female) (2) Resistance Max.

1z 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between STC1 (female) (2) – TL2 (female) (2) with chassis ground Resistance Min. 1Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (2) – (21) 0.5 – 4.5V