TROUBLESHOOTING ERROR CODE DLF1KA ERROR CODE DLF1KA (TRANSMISSION BEVEL SPEED SENSOR: DISCONNECTION (KA)) Circuit diagram related to transmission output speed sensor D85EX-15 20-531 (1) Action cod e Error code C ontroller code Trouble Transmission bevel speed sensor: Disconnection (KA) (Steering and transmission controller system) E01 S DLF1KA t teering and ransmission Contents o trouble f • Signal is not input from transmission bevel speed sensor. Action of controller • Flashes caution lamp and turns on caution buzzer. • Assumes that transmission bevel speed is 0rpm. Problem th appears o machine at • Transmission speed cannot be monitored. n • Traction force cannot be calculated.
Related informatio • Input (rpm) from transmission output speed sensor can be checked in monitoring mode. (Code 31400: Transmission speed) n • Method of reproducing error code: Start engine and travel machine actually.
Possible caus and standard value in norm state Cause Defective transmission out- put speed sensor (Internal 1 disconnection or short cir- cuit) Disconnection in wiring har- ness (Disconnection in wir- 2 es ing or defective contact in connector) al Short circuit with chassis 3 ground in wiring harness (Contact with ground circuit) Defective steering and 4 transmission controller Standard value in normal state/Remarks on troubleshooting Defective transmission out- put speed sensor (Internal disconnection or short cir- cuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
TM1 (male) Resistance Between (1) – (2) 500 – 1,000z Between (1), (2) – chassis ground Min. 1Mz Disconnection in wiring har- ness (Disconnection in wir- ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC2 (female) (30) – TM1 (female) (1) Resistance Max. 1z Wiring harness between STC2 (female) (29) – TM1 (female) (2) Resistance Max. 1z Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Short circuit of wiring harness between STC2 (female) (30) – TM1 (female) (1) with chassis ground Resistance Min. 1Mz Defective steering and transmission controller aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC2 (female) Resistance Between (30) – (29) 500 – 1,000z Between (30) – chassis ground Min. 1z