Komatsu — ERROR CODE [DLH1LC] (ENGINE G SPEED SENSOR :SEE THE TABLE (LC))

TROUBLESHOOTING ERROR CODE DLH1LC ERROR CODE DLH1LC (ENGINE G SPEED SENSOR: SEE TABLE (LC)) Circuit diagram related to engine G speed sensor 20-532 D85EX-15 (1) Action code Error code C ontroller code E Trouble ( ngine G speed sensor: See table (LC) Engine controller system) CALL E03 DLH1LC ENG Contents of trouble • Signal of engine G speed sensor does not match to signal of engine Ne speed sensor. Action of controller • Flashes caution lamp and turns on caution buzzer. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.

Related information • Special adapter (799-601-9410) is necessary for troubleshooting for engine G speed sensor. • Method of reproducing error code: Start engine. Possible causes and standard value in normal state Cause Defective engine G speed 1 sensor (Internal disconnec- tion or short circuit) Disconnection in wiring har- ness (Disconnection in wir- 2 ing or defective contact in connector) Short circuit with chassis 3 ground in wiring harness (Contact with ground circuit) 4 Defective engine controller Standard value in normal state/Remarks on troubleshooting aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

G (male) Resistance Between (1) – (2) 1.4k – 3.5kz Between (1), (2) – chassis ground Min. 1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between EGC2 (female) (35) – G (female) (1) Resistance Max. 1z Wiring harness between EGC2 (female) (25) – G (female) (2) Resistance Max. 1z aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Short circuit of wiring harness between EGC2 (female) (35) – G (female) (1) with chassis ground Resistance Min. 1Mz Short circuit of wiring harness between EGC2 (female) (25) – G (female) (2) with chassis ground Resistance Min.

1Mz aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. EGC2 (female) Resistance Between (35) – (25) 1.4k – 3.5kz Between (35), (25) – chassis ground Min. 1Mz