Komatsu — ERROR CODE [DWN1KA] (HSS EPC SOLENOID LEFT : DISCONNECTION (KA))

TROUBLESHOOTING ERROR CODE DWN1KA ERROR CODE DWN1KA (HSS EPC SOLENOID LEFT: DISCONNECTION (KA)) Circuit diagram related to HSS EPC solenoid left 20-536 D85EX-15 (1) Action code Error code Contr oller code Trouble HSS EPC solenoid left: Disconnection (KA) (Steering and transmission controller system) CALL E03 Ste DWN1KA tran ering and smission Contents of • trouble When signal is output to HSS EPC solenoid left circuit, any current does not flow. • Action of • controller • Flashes caution lamp and turns on caution buzzer. Stops outputting to HSS EPC solenoid left circuit. Limits operation of engine and transmission.

Problem that • appears on • machine Once machine is stopped, engine speed is limited to medium (half). Once machine is stopped, travel is limited to F1 and R1. • Related information • Output (Current) to HSS EPC solenoid left can be checked in monitoring mode. (Code 50600: Left HSS solenoid output current) Method of reproducing service code: Turn starting switch ON and operate PCCS lever (for steering to left). Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting Defective HSS pump sole- 1 noid left (Internal discon- nection) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

HSA (male) Resistance Between (1) – (2) 5 – 15z Disconnection in wiring har- ness (Disconnection in wir- 2 ing or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between STC3 (female) (25) – HSA (female) (1) Resistance Max. 1z Wiring harness between STC3 (female) (3) – HSA (female) (2) Resistance Max. 1z Short circuit with power 3 source in wiring harness (Contact with 24V circuit) aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Short circuit of wiring harness between STC3 (female) (25) – HSA (female) (1) with chassis ground Voltage Max.

1V Defective steering and 4 transmission controller aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. STC3 Resistance Between (25) – (3) 5 – 15z